Fail-Safe Ways to Protect Your Water Heater From Corrosion
Expert Solutions for Your Plumbing Problems
Corrosion is a common problem that can lead to costly water heater repair in Roswell, GA. It is primarily due to improper water chemistry or water hardness, but other issues like high temperatures and low pH levels can also contribute to water heater corrosion.
Here are some fail-safe ways recommended by Integrated Plumbing Solutions to help ensure your water heater lasts as long as possible:
Check the Anode Rod
The anode rod is a protective device made from metal, usually magnesium or aluminum. It’s designed to attract corrosive elements and rust, thus protecting the inside of your water heater tank. Over time, however, the anode rod can become corroded itself, making it unable to perform its duties.
Checking the anode rod and replacing it when necessary is essential to water heater maintenance. A sure indication that the rod needs replacing is when more than half its original size has been depleted.
Install a Water Softener
Hard water contains minerals like calcium and magnesium, which can leave deposits inside the water heater tank and cause it to corrode over time. A water softener removes these minerals from your water supply, making it less likely for corrosion to occur in the future.
Flush Your Water Heater
It is advised that you empty your water heater tank at least once a year to remove built-up sediment, which can cause corrosion and limit the unit’s efficiency.
Flushing is a reasonably straightforward process involving attaching a garden hose to the drain valve and running it until all the water inside has been emptied. Once finished, open the pressure relief valve to allow any remaining sediment to come out. Doing this can help keep your water heater functioning optimally, extending its lifespan and saving you from premature water heater replacement.
Temperature Adjustment
Too hot of a temperature setting can also contribute to corrosion, so adjusting your water heater’s thermostat as needed is essential. The average household typically keeps its setting at 120 degrees Fahrenheit – both for a traditional tank model and a tankless water heater. This is hot enough for efficient heating but low enough to prevent corrosion.
Integrated Plumbing Solutions is the go-to expert for all your water heater needs. We provide water heater installation, repair, and maintenance services for all makes and models. Contact us today to schedule an appointment.